may be onto something. When you're finished, you might be able to turn that
empty beer can into a Wi-Fi extending DIY parabolic (alcoholic?) antenna. Wi-Fi
range in the house not getting right then don’t get bothered but rather that
that it is justified, that sometimes there is very little technical fault that
can be easily adjusted. When your life is nothing but trolling and viral
videos, having a bad wi-fi connection can be incredibly irritating. Poor
loading times, lost connections, and more can put a strain on your time. We are
going to tell you how empty beer cans can be used to strong a Wi-Fi signal.
Why is the Wi-Fi signal tarnishing ??
Signals failure can be many reasons in the home. The largest cause does of
something to come between the router and the device. Many times people put
TV, fridge etc. in front of the router,is a major difference caused in the router
signal. It is one of the biggest causes of brake signal. Any
electronic device forward to router could damage your speed Wi-Fi signal.
Wi-Fi at home can make metal Reflector:-
With the help of Empty beer cans or soda bottles, metal reflectors can be made
.You can send Wi-Fi signal in the same direction at home. From this, both the
speed and the signal will be affected in Wi-Fi connectivity.
Put your Wi-Fi router in its (proper) place:- The right place, not under
the kitchen sink. For the strongest possible wireless connection, position your
Wi-Fi router on a flat surface off the floor, closest to the center of your
home, if possible. Somewhere up high and out in the open is best, away from
thick, dense brick, stone, metal or concrete walls that could hamper the
signal. Be sure to station your router so that signals will go straight through
walls, as opposed to at an angle. Wi-Fi signals significantly weaken when they
hit walls at angles, according to Verizon even some wallpapers hinder Wi-Fi
What do you need:-
* Empty can of beer
*cans for cutting sharp-edged knife
* Tape to paste
STEPS TO MAKE:-
1) Firstly wash aluminum beer or soda cans well to make Metal reflectors. Note cans for the
Wi-Fi route should be thoroughly dried before they are used.
2) Now with a knife cut the aluminum cans. Complete disconnect the below part and leave a little place on the top part . With scissors cut the tip of the fullest part of Can and left a little part. Now Can will look like the picture above.
3) Now you can fix the lid of beer on the router Antenna (as in the photo) ordered. Use tape to fix. The double side tape will stick more easily. It also can be rotated accordingly. The metal reflectors may also be on the same side of the turn signal on.
Follow Folks Thought on Facebook, Instagram and Twitter. For the latest news, tech news and live updates checkout http://folksthought.com